Dirt in the fuel tank attracts rust, which can erode and create rust holes in the fuel tank.Even a fuel tank that looks very clean on the outside often has more rust than expected when you take a peek inside. The worst thing you can do is turn a blind eye to the sudden fuel …
From large motorcycles to moped models, headlights are now always on, even during the daytime. When replacing the bulb=glass bulb, rather than the LED-based headlights that are common in newer models today, there are various commitments and things to do when replacing parts.Here, we will explain the key points you need to know when replacing …
Procedure in Replacing Bulb out of Headlight! Be careful When replacing! | News Read More »
You set off on a touring trip with your motorcycle friends. If you have to wait at a traffic light for a long time, you may have many opportunities to exchange information. There are probably a surprising number of riders who have looked at their friends’ meters while riding side by side and wondered why …
Whether the Meter Display is Correct or Not! Check it Out with our Mobile App! | News Read More »
When the front and rear suspensions work well, the ride quality improves and cornering becomes smoother, which are all good things. The shortcut to modifying the rear suspension is to replace the shock unit, but the condition of the lubrication of the swing arm pivot and moving parts of the linkage determines the operation of …
This time, I would like to talk about the regeneration of the water-cooling system, which I believe is the reason why my CBR1000F (SC21) became immobilized. Since the SC24, the successor to the SC21, the water-cooling pipes have been changed significantly, and many water-cooling-related parts for the SC21 are rare and hard to find, so I …
[DIY Restoration by Red One] Managed to Revive the Water-Cooling System | News Read More »
Unichrome plating is one of the surface treatments, along with decorative chrome plating, that is widely used on motorcycles and motorcycles. Unichrome plating is less expensive to reproduce than chrome plating, but the effect is clear, so there are many tinkerers who use it when restoring their motorcycles. Table of Contents Chromate treatment after zinc …
In the previous part, we have mainly polished and cleaned up the engine block, but we have found that the impression is not good because the rubber and other parts of the harness for sensors and electrical components have deteriorated, and some parts rust quickly without painting, so we detailed the painting and repair of …
[DIY Restoration by Red One] Freshened Up the Rusty Engine. | News Read More »
The steering stem bearing is a critical part that affects the handling of the bike. Whether it is a ball bearing or a tapered roller bearing, a scratched or dented race must be replaced, and the inner race that is press-fitted into the steering stem bearing must be extracted and hammered in to avoid damaging …
Stem Bearing Assembly Techniques That Make or Break Handling | News Read More »
The main stand, which is commonly installed on discontinued and old motorcycles, is a useful part of lubricating the chain and attaching and detaching the rear tire. When the main stand is removed for restoration or to grease up the pivot shaft, it is often difficult to install the strong spring. Table of Contents Return …
Motorcycle Restore Gateway. Dramatically Easier Main Stand Spring Installation | News Read More »
There are many such cases for various reasons where we really want to reassemble the engine with the current cylinders. In such a time of need, a professional store for internal combustion engine machining can do a wonderful job. For example, it is possible to repair a cylinder that has already been oversized to its …
The Inside of the Cylinder is Rusted Out! Is there Any Way to Fix it!? | News Read More »